Kirkland Dryer Repair
Although Kirkland Dryer Repair technicians use advanced tools and equipment, you can repair some components with tools that are sold at most hardware stores.
Dryer Won’t Start
A dryer has a thermal fuse that shuts off the power whenever the unit overheats. If your dryer won’t function, inspect this fuse first. You can use a continuity checker or an Ohm meter to test the fuse. If the fuse is blown, it must be replaced because you cannot reset it.
A faulty dryer control panel can also make the dryer fail. If the unit makes a sound after you activate the start button, the motor is defective and should be replaced.
Clothes Dryer Repair – Malfunctioning Cycle
The drive motor is a component that spins the drum and the blower wheel. The rotating action helps the dryer exhaust air. If the motor is noisy after the dryer stops, an item may be stuck in the blower wheel. To troubleshoot this problem, spin the drum by hand while the belt is off. If the drum does not spin freely, figure out what is binding the drum. If the drum still doesn’t rotate freely after the blower wheel is cleared, the motor is defective.
Kirkland Elite Dryer – Extended Drying Time
A clogged venting system can affect the length of the drying cycle because air will not flow properly through the appliance. By cleaning the entire venting system, the dryer will dry your clothes faster and more efficiently. To avoid future problems, clean the vent cap once a year.
A plugged or damaged blower wheel will extend the drying cycle as well. The blower wheel and the drive motor are attached together in the dryer. Both components pull air through the rotating drum. To test the blower wheel, detach the vent from the dryer. If air does not flow out of the vent, replace the blower wheel.
The heating element warms the air in the dryer. If this component fails, your clothes will not dry quickly. When the element burns out, a skilled technician must repair or replace it.
Stackable Washer Dryers – Overheating
The temperature in a dryer will increase if the heating element is defective. The element will produce heat all of the time if it slightly shorts out. To inspect the element, carefully remove it from the dryer. If the coils are touching each other, the element must be replaced.
Dryer Repair Advice for Homeowners
All dryers have a door switch that activates the other components. If the door is not properly shut, the appliance will not operate. Many units also have a reset button; whenever the motor won’t function, press this button after the dryer rests from 10 minutes.
Before you implement any maintenance procedures, unplug the dryer and detach the grounding wire. If you own a gas-fueled unit, shut off the gas-supply valve and the gas line that runs to the unit.
When disassembling the dryer, remove the bolts or screws that hold the side and top panel in place. Then, remove the front panel by pulling it away from the cabinet. To access the control panel, remove the screws carefully; they usually have a plastic or metal trim over them. If the trim is tough, you may have to pry it off with a stiff tool.