A Frigidaire gas range, dual-fuel range, and various electric ranges have state-of-the-art components. This is why a range repair Oxbow technician should handle complicated maintenance projects. However, if you have some mechanical knowledge, you can tackle simple repairs without hiring a stove repair Oxbow technician.
Gas Stove Problem – Ignition Delay
A delayed ignition often happens when the ignition components are blocked. A Frigidaire range repair Oxbow professional can determine if there is a clog near the ignition port. This range problem should be repaired immediately because a blocked port can cause an explosion or a fire.
Induction Range Problem – Blown Fuse
The fuse is found underneath the range, so you must open the appliance to access it. Ensure that the electricity is turned off before beginning the project.
Inside the range, you will find the fuse near a coil. Unscrew the fuse slowly and remove it carefully; do not let the fuse touch the metal components.
After the old fuse is out, screw the new one firmly into place. The replacement fuse should have the exact voltage as the old fuse. If the new fuse has a greater or lower voltage, it could burn out or trip.
Steam Cleaning Frigidaire Electric Range Problem – Faulty Coil
When a coil does not produce heat, there is a problem in the plug-in area. Turn the appliance off and remove the deflective burner. Then, place the burner in another plug-in location. If the burner does not heat up after energy is restored, you will need another burner.
Most coils will gain cracks and bubbles over time. Whenever a burner has any signs of wear and tear, it should be replaced because a damaged burner cannot be repaired.
How to Replace a Temperature Control Probe
You must wear safety gloves while tackling this appliance repair Oxbow project. Do not implement any procedures until all components in the oven are completely cool.
Step One
Turn off the electricity that runs to the range or oven. Most units will have a double breaker or two fuses. To avoid an electrical shock, shut down both breakers or remove both fuses.
Step Two
Take the oven racks out of the appliance. Then, locate the temperature sensor probe in the oven near the back wall.
Step Three
Move the temperature probe to the center of the oven. The wires that are attached to the probe should have stack, so you can pull the sensor a few inches forward without any issues. While pulling, guide the wire connector through the gap in the interior wall with needle-nose pliers.
Step Four
Grab the connector with the pliers and remove pressure from the locking tab. Then, detach the plug from the probe. You must move the connector slowly so that it won’t go back through the gap. If the connector slips, you will have to retrieve it by removing the panel at the back of the oven.
Step Five
Grip the connector with your pliers and snap it into the new probe’s plug. Finally, move the wire back into the oven.