Bosch front lots washing machine presents an e13 error code. It means that the issue relates to water draining. If after the timeout (10 minutes) the water remains in the container and is not drained pipes, the system offers an error. The device reveals it on the scoreboard.

The customer notifications the lack of rotating when it pertains to securing wet clothes from the container. How to remove the issue as well as repair the break down?
What does the e13 error of Bosch front lots washer mean: reasons for failure as well as its elimination
To recognize why Bosch front load washing machine produces the e13 mistake, act sequentially. Begin checking from simple as well as easy to understand information. Adhere to the actions:
Check the drain filter. The element is located at the end of the tool’s back. Open the cover as well as remove the filter. If it is loaded with debris, tidy it and rinse under running water.
Examine the drainpipe hose pipe for bending or incorrect location. If it is not set up correctly, a “siphon” result is created. As a result, only the water begins to combine, it right away returns to the washing machine. Additionally, clean the hose pipe and its nozzle.
The obstruction can create in the sewer system or in the connection factor of the hose pipe with it. The last option can be examined by detaching the pipe. If the cause remains in the drain, you will require to cleanse it with special ways or call a plumbing.
What to do if after cleaning all the elements the e13 mistake code does not reset? To fix the problem, you need to repair the breakage by yourself.
Pressure switch breakdown
How to check a stress button? Initially, remove the stress sensor from the Bosch washer. Having attached a little tube to the accessory factor, strike it through. Furthermore, examine the hoses causing the stress switch for honesty and also lack of blockages.
If the sensing unit is in order, contacts will work after blowing the tube. You will certainly listen to a particular click, which can be duplicated 3 times. If you do not hear anything, the replacing of the pressure switch is called for.
Transmission belt failure
If the Bosch washer shows the mistake code and also the spin does not function, the factor for it might remain in the transmission belt of the engine. When the belt stretches, the transmission of turns is inefficient. As a result, the washing is normal, yet there is not enough rate to spin, which creates the e13 mistake.
To inspect the condition of the belt, do the following:
After separating the Bosch front tons washer from the electric network, remove the back cover.
Look, perhaps, the belt has actually jumped off the sheave, or is also put on.
To mount a brand-new belt, thread it via the pulley-block of the electric motor onto the pulley of the drum.
Scroll the pulley-block, uniformly distributing the belt.
If there are no results after resetting the error and also resuming the spin, most likely to the following action.
Drain pump break down
When the pump fails, the water is drained poorly or otherwise whatsoever. So, prior to inspecting the filter and also the drainpipe pipe, you can begin inspecting the pump.
Drain the water from the Bosch front lots washer via the drain filter.
Eliminate the top and also back panels of the washer.
Repair the drum as well as put the tool on its side.
Disconnect the pump cords, located at the end of the washing machine.
Relocate the tube secure far from the pump.
Transform the pump counterclockwise as well as pull it out.
To install a new component, press it strongly by transforming it clockwise.
Control device concerns
The last thing that can be assumed is the control module breakdown. If there are any problems with electronic devices, the rest of the washing machine does not receive a beginning signal. Hence, the gadget educates about the e13 mistake.
Each different component on the control board takes care of the procedure of the motor, engine, sensing units and also various other components. As a result of the closure, the components can stress out. To deal with the damage, attempt to solder the calls, clean the system or do the full replacement of it.