Water does not get in the equipment or cleaning agent is not gotten rid of. Indication light “spin” is lit and also a display is blinking E11.

If the e11 mistake code appears on the display screen of the Bosch washing device, check the complying with factors:
The tap of the supply of water to the washing device is blocked.
Low tide pressure in the supply of water.
The filter in the hose of the cleaning machine is blocked.
The water hose pipe of the cleaning maker is twisted.
Aquastop ® Hose pipe safety and security feature is triggered.
Activation of the Aquastop system
The e11 mistake code of the Bosch cleaning maker has actually occurred due to the AquaStop and Leakage security system activation
AquaStop and Leak defense system are essential to turn off water as well as shut off the device. It’s vital in cases of a tear of a fill pipe or leakage inside the washing machine
The AquaStop system functions as complies with. The water inlet hose pipe goes through an external one, which is wider. If the inner hose pipe bursts or tears for some reason, water will not flow to the floor, but to the external hose pipe. After this, the shutoff at the inlet of the filling tube immediately closes the water.
Such a feature implies that there is a sensor in the cleaning maker bottom. If water gets into it when leakage happens, the Aquastop system stops the water acquiring. As well as the digital control system gives the command to drain it.
In rare instances, washing machines, outfitted with defense versus leaks, show dud of the water sensor. Hence, when the device is turned on, the drainpipe pump instantly starts working. When this happens, the washing procedure does not begin. The reasons for this can be either in the digital control system or in the sensing unit itself. One of the methods to solve the problem is closing the wires around the sensing unit.
Just how to clean up the water filter in the washing device.
Disconnect the cleaning machine from the electrical outlet.
Close supply of water so that it does not enter the cleaning device. If you do not have a different faucet for the device, shut the chilly water supply in the entire apartment or condo. As a rule, the crane is located alongside the meters.
Prepare a rag and also a tiny basin of regarding one-liter capability. Move the home appliance far from the wall surface to obtain accessibility to the tubes.
Locate the filler hose pipe as well as start to transform it anticlockwise. When the hose begins to turn off quickly, place a dustcloth and also basin under the hose pipe, and transform it throughout. Some water will put out of the part.
Utilizing tweezers or pliers, remove the filter and also wash it under the water. If you are blocking water in the whole house, direct the hose to a bathtub or sink and ask somebody to turn on the water. After that, water will move from the tube as well as you may clean the filter with it. Afterwards, close supply of water once again.
Install the filter in the washing equipment.
Screw the tube back by turning the internal screw clockwise. Tighten it with medium initiative.
Activate the water and inspect that there is no leak under the inner screw. If water circulations, after that you must have screwed the hose pipe not by the string or tightened it somewhat. Close the water, get rid of and fasten the tube again.
If the hose pipe does not leakage, turn on the cleaning equipment.